Charging
- USB-C power: 5 V, 1–2.4 A.
- Solid red: charging.
- LED off: fully charged.
- About 2.5 hours to charge.
- Up to 35 hours playtime.
Watch: connect USB-C power and check the charging indicator.
Start setup
Join your kit broadcast
Join the Venucast kit broadcast
Turn on the Venucast kit transmitter.
Slide the Aria Aura power switch to ON. The LED blinks orange while it searches for a nearby broadcast.
Stay near the kit transmitter. The LED turns solid orange when Aria Aura joins the broadcast.
Watch: turn on Aria Aura near the kit transmitter and check for a solid orange LED.
Done: the Aria Aura LED is solid orange and you can hear the kit broadcast.
Want a different broadcast? Hold the Multi-Function button for 5 seconds. The LED blinks orange while scanning; repeat to scan the next broadcast. Stop when the LED is solid orange on the broadcast you want.
Fix a problem
Fix an Aria Aura broadcast problem
Aria Aura does not join the broadcast
Flashing orange? Aria Aura is searching. Turn on the Venucast kit transmitter and keep the headphones nearby.
- Turn Aria Aura ON.
- Hold the Multi-Function button for 5 seconds to search again.
Joined: the LED turns solid orange. To scan another broadcast, hold Multi-Function again.
Still flashing? Perform a DFU firmware update ↓ with the included gray USB data cable. If that fails, contact Venucast Support.
Aria Aura is joined but there is no sound
Symptom: the Aria Aura LED is solid orange, but you cannot hear the intended audio.
- Check that the kit transmitter and its audio source are on.
- Hold the Multi-Function button for 5 seconds to search for another broadcast.
- Repeat the search if more than one broadcast is nearby.
Done: the LED is solid orange and you can hear the intended broadcast. If not, contact Venucast Support below.
Need to join a secured broadcast?
For a secured Auracast broadcast, contact Venucast Support for help with access. This guide does not provide a passcode.
Reference
Power, charging, buttons, and indicators.
Connection indicators
- Orange flashing: searching for Auracast.
- Solid orange: Auracast joined.
Full button guide
The Multi-Function button searches or switches broadcasts. The EQ button selects Voice Clear 1, Voice Clear 2, Bass, or Balance. The LED blinks orange while searching and is solid orange when joined.
Open buttons & indicators ↗Firmware update
Check for Aria Aura updates.
Firmware may provide fixes or improvements. Use only the official Aria Aura update page and follow the instructions shown there.
1
Download the updater
Open the official page and install Avantree Firmware Updater for Windows 10 or later, or macOS 10.14 or later.
2
Connect Aria Aura
Disconnect Aria Aura from other devices. Connect it to the computer with the included gray USB data cable.
3
Complete the update
Follow the updater through its final Reset Device step. Keep Aria Aura connected until completion is confirmed.
During an update: do not turn off or disconnect Aria Aura, and keep it disconnected from all other devices until completion is confirmed.
Need more help?
Our support team is here for you.